10/13/2019 Megacli For Vmware
Megacli Commands Description Command To check all physical disk status.
This entry was posted by S.M.A.R.T – can be used to monitor and report on the health of storage devices attached to JBOD drive controller. Each storage device maintains SMART counters that can provide detailed information on the status of each storage device. To monitor the health of storage devices attached to RAID controllers requires the use of WebCLI, StorCLI or MegaCLI. LSI StorCLI is the successor of the MegaCLI tool and provides a commandline interface to LSI and IBM MegaRAID drive controllers. In this article we present a number of examples of useful StorCLI & MegaCLI commands. Installation. (lsi.com) under Management Software and Tools.
Vmware esxi 4.1 ibm lsi raid megaraid rebuild. According to many posts, it is possible to install the MegaRAID Storage Manager (MSM) on either a VM or a remote box and monitor the LSI RAID controller in the IBM x3500 series running VMware ESXi 4.1. I have not been able to get any version to work - either on a guest or from a remote box.
Older utility. Utilization Information for general use:. /cx bzw.
/vx stands for the Controller/Virtual Drive Number. /sx stands for the Enclosure/Slot ID. Additional information is also available in the (www.lsi.com) Information on the existing hard drives and their status (IDs,). Sudo storcli /cx /vx del cc MegaCLI Adapter parameter -aN The parameter -aN (where N is a number starting with zero or the string ALL) specifies the PERC5/i adapter ID. If you have only one controller it’s safe to use ALL instead of a specific ID, but you’re encouraged to use the ID for everything that makes changes to your RAID configuration. Physical drive parameter -PhysDrv E:S For commands that operate on one or more pysical drives, the -PhysDrv E:S parameter is used, where E is the enclosure device ID in which the drive resides and S the slot number (starting with zero). You can get the enclosure device ID using “MegaCli -EncInfo -aALL”.
The E:S syntax is also used for specifying the physical drives when creating a new RAID virtual drive. Virtual drive parameter -Lx The parameter -Lx is used for specifying the virtual drive (where x is a number starting with zero or the string all).
Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |